Skip to the stories
Climate Science

EV Charging in Indian Apartment Blocks Hinges on Shared Power Systems

By Letters to the Editor 941 views

Transformer capacity, long cable runs and building approvals complicate home charging in Indian high-rises. Load management and shared hubs offer practical ways forward.

EV Charging in Indian Apartment Blocks Hinges on Shared Power Systems

For many Indian city drivers, the hard part of owning an electric car may be getting a reliable charge at home. Around 70% to 75% of urban households in major Indian metros live in multi-family apartments or cooperative housing, according to data from Kazam and the Alliance for an Energy Efficient Economy. Their parking spaces may be at ground level or several floors below it, far from a private electricity meter.

That layout changes the engineering and cost of charging. A charger that works well in a detached house can strain a shared transformer, require a long and expensive cable route, and raise questions for a building’s residents’ committee. The practical answer is usually coordinated electrical infrastructure, rather than a separate installation planned for each car.

Evening charging meets the building’s peak demand

Apartment complexes generally draw power through a shared connection sized around the combined demand of residents. The calculation assumes that not every air conditioner, water heater, lift, pump and kitchen appliance will run at full power at the same time. Several cars charging together can upset that assumption, especially during the evening peak.

A typical domestic water heater may draw 2 kW for about ten minutes before switching off. A 7.4 kW wall charger, by contrast, can draw 32 amps continuously for six to eight hours. If several drivers plug in around 8 p.m., that sustained load arrives when cooling and cooking already push up demand.

Consider a 100-flat complex with a 250 kVA transformer. At a residential power factor of 0.85 to 0.90, its real power capacity is about 215 to 225 kW. On a hot summer evening, household demand can reach 75% to 85% of transformer capacity: 187 to 212 kVA, or about 165 to 190 kW. The remaining headroom varies with conditions, but 30 kW is a sensible planning figure.

Five or six cars charging at 7.4 kW would add 37 to 44 kW, enough to consume that estimated buffer. Eight cars would demand 59.2 kW. Without active controls or additional capacity, simultaneous charging at that level can overload the transformer. A breaker may trip, interrupting power to shared facilities, or the complex may face higher charges tied to its peak demand.

Adding transformer capacity or increasing the approved supply can take significant funding and space, as well as time to arrange. That makes managing when vehicles charge a central part of the solution.

Long routes add cost and installation constraints

In a high-rise, the parking bay may be far from the meter and electrical distribution equipment. A route of 80 to 120 metres can connect a meter room or service shaft to a car parked in a basement. At 32 amps, cable size and installation quality matter: voltage drop and heat make ordinary 4 or 6 sq mm household wire unsuitable for this use. The described installation calls for 10 sq mm armoured copper cable.

The charger also needs a dedicated circuit and protective equipment. The specifications described include a 40A Type C miniature circuit breaker, a 30 mA Type A residual-current device with overcurrent protection, and an earthing pit tested below 2 ohms. Certified chargers handle pure 6 mA DC fault detection with an internal detector.

Armoured cable, metal conduit, switchgear and skilled labour can bring wiring costs to ₹25,000–₹50,000, or about US$280–560. That can match or exceed the wall charger’s retail price. There is also a shared-space issue: one resident may be able to route a cable through a riser, but installations for ten or fifteen residents can crowd shafts and basement cable trays, creating a fire hazard.

Shared parking calls for shared decisions

Residents commonly need approval from their housing society committee or Resident Welfare Association before installing charging equipment. Committees may lack electrical expertise and have to weigh several practical concerns: fire safety in enclosed parking areas, fair billing, and the effect of individual installations on common wiring routes.

Billing becomes harder when a charger uses shared building power rather than a resident’s own metered supply. The complex then needs a clear method to account for the electricity used, including line losses and any added peak demand. A consistent installation plan can also help avoid a first-come, first-served tangle of cables through shared areas.

In Amit Dholakia v. The State of Maharashtra (2025), the Bombay High Court pressed for clearer guidance to prevent housing societies from rejecting charging requests arbitrarily. In early 2026, the Supreme Court of India issued notice on a public interest case challenging charger bans across states. These developments point toward clearer protections for residents who want to charge at home, though resolving a particular installation still depends on the building’s electrical design and approval process.

Three ways to make home charging fit

Installing a separate cable from every flat’s meter may work for a small number of cars, but it becomes difficult to manage as adoption grows. Three approaches can help apartment complexes plan for more vehicles.

  1. Dynamic load management: Smart chargers track the building’s electrical load and adjust charging accordingly. During the evening peak, they can reduce output to 2 kW or pause; after midnight, when demand falls, they can increase charging speed. The aim is to keep total demand within the transformer’s limits while completing charging overnight.
  2. Shared charging hubs: A complex can set aside three to five parking bays near its main electrical room, reducing the need for long individual cable runs. Charge Point Operators can install and manage the equipment through an app-based revenue-sharing arrangement, with little or no upfront capital expense for the society.
  3. Separate metered connections: Some Indian utilities allow housing societies to apply for a dedicated connection for EV charging, with discounted green tariffs. A separate line and meter can distinguish vehicle charging from household use and ease pressure on the building’s existing supply.

India’s shift to electric two- and three-wheelers is advancing, while passenger cars still need convenient charging where people live. For apartment residents, a dependable overnight charge depends on more than the vehicle and the charger: transformer headroom, safe cable routes, transparent billing and a workable plan for shared parking all matter. Buildings that address those needs together can make home charging practical for more residents.

Source: Letters to the Editor · cleantechnica.com

From the same basket